Chloride Ion Sensor

1.Chloride Ion Sensor application environment description

Chloride Ion Sensor is a solid ion selective electrode that can measure the total free chlorine content in water with fast response and accuracy.The S14 Chloride Ion Sensor uses an ion-selective electrode to test free chloride ions in water.It is fast, simple and economical and can meet the measurement requirements of chloride ions in most industrial environment applications.

Signal output: RS-485 (MODBUS-RTU)

2.Chloride Ion Sensor technical parameters

3.Chloride Ion Sensor maintenance and care

In order to obtain the most stable results, it is recommended to soak the ion-selective electrode in a standard solution (usually 100ppm) for 10-15 minutes before measurement until the reading is stable.

In order to obtain high-precision results, it is recommended to repeat these steps: remove the electrode from the standard solution, clean it, blot it dry, and then immerse it in the standard solution (soak for at least 2 minutes to obtain a stable reading) to ensure that the electrode is properly rinsed and preprocessing.

When the electrode is used for the first time or is used after long-term storage, it needs to be soaked in the standard solution overnight or even 48 hours to obtain stable readings.After pretreatment, spray the electrode with deionized water and carefully blot it dry with absorbent paper rather than wiping it dry.

Place the sensor upright when not in use.Do not place it horizontally for a long time.

The electrodes should be kept dry when the sensor is not used for a long time.